On vehicles from 1985-1995, the VIN can be found stamped on the frame in the right-hand side foot well. For model year 1997, the VIN was stamped under the seat, on the right hand frame rail near the airbox (C). Model year 1996 vehicles have a VIN stamp either on the right side, in front of the shift selector box (A) or under the seat on the upper shock mount cross member (B). The below photo shows the location of the VIN on a 2005 Predator. Sportsman 570 6圆 models from 20 also feature a VIN stamp in the right rear wheel well.įrom model year 1998 until 2010, all VIN stamps can be found on the frame in the front left wheel well. On Sportsman XP 1000 S and Scrambler XP 1000 S models, the VIN is stamped in the right rear wheel well. Where the VIN is stamped depends on the model of your vehicle.įor ATVs from model year 2011 to the present, the VIN usually is located either in the front left wheel well or the back left lower frame rail.įor Scrambler models Sportsman 550, 850 and XP 1000 models Outlaw Trail Boss Trail Blazer and 2011 Hawkeye models, the VIN is in the left front wheel well.įor Sportsman 400, 450, 500, 570, 800 and ETX models 2013 Hawkeye models and Sportsman 6圆 models from 2011-14, the VIN can be found on the left rear frame (1). Prior to that, a VIN was only seven digits. On vehicles from 1997 and newer, the VIN is 17 digits. Note that if you have replaced the engine, this information does not apply. Include your question, the engine serial number and any information about the vehicle that may assist in identification.

If you are unable to locate or read your VIN but have an engine serial number, use the Contact Us options at the bottom of the page for assistance with vehicle identification. Replace the controller if any of its components, such as the NVRAM, cooling fans, or NIC, have failed.The Vehicle Identification Number (VIN) of your Polaris ATV is a unique number used to identify your vehicle. The array can function with one healthy controller while the replacement is installed. ESD strap Support contact: support 1.877.364.6253 x2 (US only) +1.408.432.9600 x2 (outside the US) If one controller fails, the other controller takes over.Time required: 10-30 minutes Part required: Replacement controller ordered from Nimble Storage I n f o r m a t i o n r e q u i r e d : (Step 3) Use this quick start guide to replace a controller in your Nimble CS array. During controller replacement, you must remove the USB stick from the fa iled controller.Determine the Nimble OS version running on the array.Veri fy that the replacement controller m atches the part shown on the RMA work order.Determine whi ch controller to replace befor e making the replacement.While a controller is removed, the internal temperature of the chassis can rise to critical levels. Do not remove the fai led controller unti l you are ready to i nstall the replacement.

Find nimble serial number